When making any cuelist with more then one cue, and entering a wait time on both to create a loop. I export it to the device using the auto continuous mode in the export options. It enters a couple extra black frames that cause the output to go black for a split second.

Here is a video demonstrating it:
http://homepage.mac.com/ryanwilkinson/ecuebug.mov

Both red and green cues have a fade time of 2 seconds and a wait time of 2.5 seconds. Nothing special. Doing the same exact thing on v5.1 works just fine and does not blink black.

Hi Ryan,

could you please send me the show?
Which programmer 5.2 version do you use?
In which programmer 5.1 version did this setup work?

Thanks,

Bartek

Version 5.1.601.960 Enterprise
Version 5.2.173.1309 Enterprise
Butler XT Firmware V1.4.118 (tried it with 1.3.3 and there was no change)

If you upload this show onto a butler, press the B button on the butler to start it. It starts QL11. The show I am putting on here is the one I originally created with 5.2.

http://homepage.mac.com/ryanwilkinson/bugshow.zip

Hi Ryan,

please use a Release Time of at least 1 second in your cue list properties.
This should make the flicker invisible.

Please recheck your 5.1 show, as I expect the release time there to be greater zero, too.

Regards,

Bartek